Post by tdonnellyem on Jul 8, 2014 19:02:34 GMT -5
hello all,
i have a savage model 24 p series 22 over 410. both shoot fine but i do have a few issues with the gun.
1) the .22 extractor is very stiff and i almost need pliers at times to pull the 22 shell out. i don't know if its the spring thats worn out or not-figure it is and have ordered new one. so dumb question-how do you install the extractor properly? I'm assuming put new spring in/put extractor all the way in flush with end of barrel/tighten extractor screw. if this is wrong please set me straight.
2) the gun has a folding rear sight on top of the .22 barrel. it seems to be up as high as it goes but the rifle still shoots low. any remedies besides "kentucky elevation" to get the gun to shoot a bit better with the sight?
thanks for any/all help with this rifle.
tim
i have a savage model 24 p series 22 over 410. both shoot fine but i do have a few issues with the gun.
1) the .22 extractor is very stiff and i almost need pliers at times to pull the 22 shell out. i don't know if its the spring thats worn out or not-figure it is and have ordered new one. so dumb question-how do you install the extractor properly? I'm assuming put new spring in/put extractor all the way in flush with end of barrel/tighten extractor screw. if this is wrong please set me straight.
2) the gun has a folding rear sight on top of the .22 barrel. it seems to be up as high as it goes but the rifle still shoots low. any remedies besides "kentucky elevation" to get the gun to shoot a bit better with the sight?
thanks for any/all help with this rifle.
tim
