|
Post by gman on Jul 28, 2014 14:25:04 GMT -5
I have a 22/410 with the side button selector. I have the "new" hammer with the selector built-in. Is that the only part I need to make the conversion?
|
|
|
Post by cas on Jul 31, 2014 15:18:34 GMT -5
The question is, what do you need to remove if anything. Don't know.
|
|
|
Post by gman on Jul 31, 2014 17:20:50 GMT -5
I am pretty sure I know what needs to be removed, but I have found some people mentioning "hammer conversion" Kits that include new firing pins they claim that the pins are differant from the existing ones. Probly not really needed as I cannot find multiple part numbers for firing pins, but was wondering...
I found discussions that hammer conversions apparently at first do not hit the firing pins the fix according the internet is this: mainspring is naturally slanted upward about 10degrees. bent it downward about 20 degrees and it forces the hammer farther forward.
I was hoping some one here has done the conversion before and could advise me as to what possible issue and what other part they found were needed.
|
|