|
Post by savage44 on May 5, 2022 21:00:50 GMT -5
Just bought a 24e in 22mag 410..think its a 1962 model..has hammer barrel selector but no serial num..cant find much listed about the 24e..any information would be appreciated
|
|
|
Post by msdibble on May 19, 2022 20:01:40 GMT -5
I have the very same gun. 22WMR over 410. No serial number. My top 22WMR firing pin does not protrude. I believe it is broken off. Any ideas where I might find information or parts for this firearm? Is the 22LR firing pin the same as the 22WMR? Thanks for ant feedback.
|
|
|
Post by mnbobster on May 25, 2022 8:05:55 GMT -5
|
|
|
Post by msdibble on May 25, 2022 8:18:10 GMT -5
Thanks - I did see those parts in GunpartsCorp.com.
Actually, I discovered that the firing pin was slightly canted in the receiver. It was causing the rear edge of the pin to hang up and not allow the pin to move freely in the spring-loaded housing. The gun is rather old and probably have not been cleaned in some time. I simple I steered a knife into the flat slot of the back of the firing pin and rotated it slightly. The firing pin fell right back into place and now functions as it should. I cleaned it up, lubed it all a bit and then tried it out. Both barrels fired right as rain. My Uncle gave me this gun. I will always have it.
|
|
24combo
Frequent poster
If you build in a swamp you may have frogs.
Posts: 113
|
Post by 24combo on May 28, 2022 9:30:53 GMT -5
Glad to hear you were able to solve the problem.
|
|