|
Post by cw on Jan 2, 2014 13:08:18 GMT -5
Is there any way to adjust POI between the barrels of my 24c-DL? The barrels are attached along there full length.
22Mag barrel is sited dead on at 50 yards but with same zero, the 20g shooting slugs is a fill foot to the right and two inches high. The elevation is not a worry...but a foot of Kentucky windage is a lot.
I have adjusted this on other models where the barrels did not touch...but stumped here.
CW
|
|
|
Post by cw on Jan 6, 2014 11:23:36 GMT -5
Anyone?
|
|
|
Post by Mr. Polecat on Jan 6, 2014 17:57:52 GMT -5
I think you may be out of luck, aside from getting it threaded for chokes and then getting an (expensive) offset choke to correct it. I wonder how it got so far out. Are the crowns ok? If they are dinged up, getting it recrowned might get it shooting better?
|
|
|
Post by cw on Jan 7, 2014 20:54:32 GMT -5
The appear to me ''crowned'' with a chamfer tool!!! Ill try to post a pic later.. CW
|
|
|
Post by Mr. Polecat on Jan 8, 2014 6:59:48 GMT -5
Yeah, mine is like that too. Hehe.
|
|
|
Post by bigkelly on Jan 8, 2014 8:22:23 GMT -5
No regulation possible with the 24 (any model) Only savage combo able to regulate were the 2400 series guns
|
|
|
Post by cw on Jan 8, 2014 11:25:26 GMT -5
Is as afeared of that... Guess I'll buy different ammo and start shooting hoping one or more prints closer to poi. ;( Thanks for the heads up guys CW
|
|
|
Post by cas on Jan 9, 2014 14:34:09 GMT -5
This is about it.
|
|
|
Post by txbob on Jan 9, 2014 18:44:10 GMT -5
You might mount a scope with see through mounts for the rifle barrel and a peep sight for the shotgun barrel. That is what I am doing for my 24. Same solution as CAS's picture just a little more high tech.
|
|