|
Post by captjack on Aug 27, 2023 8:43:11 GMT -5
I picked up a nice 24vs 20ga/357 maximum broke it open a couple times …the thumb beak was pretty stiff tried opening third time, will not open thumb break not moving the locking mechanism i removed the two thumb tension springs but not sure how the mechanism works…don’t want to force anything see picture hoping someone here can offer suggestions for next step thank you capt jack
|
|
|
Post by captjack on Aug 28, 2023 7:17:19 GMT -5
For discussion clarity clarity, the thumb break should push the locking bolt assembly, part 49, forward to release the barrel Any ideas what may be blocking its movement Thanks Jack
|
|
|
Post by neilrr on Aug 28, 2023 7:55:30 GMT -5
captjack, welcome to the forum. The top snap (#25, thumb break) should pull, not push, the locking bolt assembly (#49) rearward or retrack it away from the barrel to allow the barrel to pivot open. Since you removed the two locking bolt plunger springs (#45 & #46) you should be able to manual pull the locking bolt assembly backward to allow the barrel to pivot open. It is possible that the screw retaining the top snap sleeve (#50) which locks the top snap to the locking bolt assembly has loosened up. If it has then the top snap sleeve will not rotate when the top snap is pushed sideways. Also, if the spring-loaded rifle firing pin is not fully retracting away from the barrel breech face can make opening the barrel hard and even prevent the barrel from closing.
|
|
|
Post by captjack on Aug 28, 2023 9:01:37 GMT -5
Thank you very much…I did say push..understand it pulls Other comments helpful I put the springs back in…no small process Going to take back out and try following your comments Thank you very much!
|
|
|
Post by captjack on Aug 28, 2023 9:14:53 GMT -5
neilrr got it…your guidance was perfect. Actually that was the easy part, now have to get those springs back in. anxious to shoot the 357 maximum, that’s a new caliber for me thank you capt jack
|
|
|
Post by neilrr on Aug 28, 2023 11:18:18 GMT -5
captjack, glad to hear that you were able to get the barrel open. I assume that the screw for the top snap sleeve was loose. When you put it back in it is advisable to use some non-permanent Loctite to ensure it does not come loose in the future, especially when shooting 357 Max. All the best.
|
|
|
Post by captjack on Aug 28, 2023 14:16:11 GMT -5
No, I actually tried to loosen the screw previously …it is at a angle so very difficult to get a common bit in there without messing the scre up It is very tight so I left it alone
|
|
|
Post by neilrr on Aug 28, 2023 18:38:06 GMT -5
captjack, If I remember correctly, due to the limited access I used a flathead screwdriver whose tip was bend 90 degrees to form the bottom of an "L" to loosen/tighten the top snap sleeve. screw. So, what did you find that was causing the barrel to lock up and not open?
|
|
|
Post by captjack on Aug 29, 2023 2:30:07 GMT -5
the locking bolt #49 was stuck, used a screwdriver to lever it back
|
|