|
Post by loganboone on Mar 21, 2013 12:31:56 GMT -5
I recently aquired a four tenner (20 ga.) and I was wondering if anyone knew the dimensions for the "O" ring that fits onto the muzzle. I intend to use it in my 24C for backyard rabbit hunting, but cannot without "O" ring. Thanks.
|
|
|
Post by savagecombo on Mar 21, 2013 13:10:54 GMT -5
I recently aquired a four tenner (20 ga.) and I was wondering if anyone knew the dimensions for the "O" ring that fits onto the muzzle. I intend to use it in my 24C for backyard rabbit hunting, but cannot without "O" ring. Thanks. I'm sure you can buy what you need in the plumbing section of hardware stores like Ace or Tru-Value. Measure to get an approx. diameter of your 410 tube and then go to the store and buy a few "O"-rings for very little money. Buy a couple different thicknesses and try each one until you receive the desired snugness. Then take the store receipt and the remaning "O"-rings that you did not use back to the store and get a refund. SC
|
|
|
Post by loganboone on Mar 21, 2013 13:37:37 GMT -5
Thanks, that is my eventual plan. I was hoping someone could cut the guess work out.
|
|
|
Post by gunner022 on Mar 24, 2013 23:11:36 GMT -5
Just buy an assorted bag in the plumbing section. I picked up a four tenner about a month ago and that worked for me. You should have some good resistance pulling the insert in and out, in fact it should hurt your fingers pulling on the extractor slide to get it out. Thats how mine is and seals the gasses properly. Good luck.
Al
|
|