|
Post by christianh on Jan 27, 2013 19:07:07 GMT -5
Hello,
I have a question for the experts. I have a 24C series S that I bought unused off of gunbroker about a year ago. I am finally getting around to cleaning the oxidized factory grease and oil out of the action so I can shoot it. The shotgun firing pin seems to float in the action and does not have a return spring. I have looked at the schematic at Numrich and it does not show a a spring with the shotgun firing pin but the factory manual shows a spring with the shotgun firing pin. Neither are accurately showing the series S with the break open lever in the trigger guard. I have some firearms with floating firing pins and they seem to work without a return spring and rebound back into the action after firing. Just need to know if this model should have one or not.
Also, although this 24C was advertised as unfired (the barrels had no powder, lead, or wad residue) it had been handled frequently and the action had been opened and closed repeatedly. The plastic forend pivot plate was slightly contacting the action and the plastic edge was slightly deformed from being open and closed - I just slightly trimmed it with and exacto knife. Also the chamber end of the barrel had pretty rough machine markings left from manufacturing and had worn away some of the finish on the action breach face - I took a diamond hone and have been lightly polishing the action end of the barrels. Has anyone else experienced this?
Thanks,
Christian Hanson
|
|
|
Post by cas on Jan 28, 2013 0:31:56 GMT -5
Welcome…. it also sounds normal to me. No firing pin spring, that's normal. (I should add that to the FAQ page) That little plastic piece behind the forend gets a bit buggered at the edge, that's also normal.
|
|
|
Post by christianh on Jan 29, 2013 1:36:01 GMT -5
Thanks,
I was pretty sure there was wasn't a spring when I took it apart. But, I still spent five minutes looking into the action with my bore light and searching the floor in case I somehow missed a spring while taking it apart.
This will be a hard use gun and will live in my 4x4. I'm doing a little polishing of some of parts and then its off to Robar for NP3 coating. The stock had some handling dings and the hardwood is pretty plain. I'm going to sand it and then seal all of the wood with Brownell's Aluma-hyde II epoxy paint. I think the combination of the metal and stock treatments should make it pretty weatherproof for the wet Washington weather. The only thing I will have to worry about are the rifle and shotgun bores. Robar won't treat the bores. I'll have to make sure to run a patch of Boesheild down the bores after every outing.
I'm also planning on getting a Skinner Sight case for it since the foam in the original cordura case that came with it has turned to dust.
Thanks for the forum and the info. I've also been slowly reading through the archive forum to pick up any tidbits.
I'll post a picture of my set-up when I get it all finished
Christian Hanon
|
|
|
Post by cas on Jan 29, 2013 5:12:46 GMT -5
When you get the finish off you might find that the wood is almost white. lol A lot of the guns from that time frame are stained (more like paint) over really really white wood.
|
|
|
Post by littleguns on Jan 29, 2013 14:47:26 GMT -5
That "missing" spring, as CAS has noted, was never there, which is what you'll find is typical of Stevens/Savage break-action shotguns (and lots of others). The absence can be beneficial -- a few years ago I ran across an old Stevens .410 at a gunshow, and the seller insisted it was defective because the spring was missing or broken and the pin just flopped around at will. He wouldn't accept my explanation that it never existed, so I ended up getting the gun for something like $35 and smiled all the way out the door.
|
|